The Road is calling… OWGrv is answering.

If using Sewer and planning to drain the tanks (this also applies to draining the tanks at a dump site after hooking up the Sewer Drain Hose):

1. Pull open the Black Water Flush Valve.
2. Connect the Green Sewer Flush Hose to the Black Water Flush Connection.
3. Turn on the water and allow it to flush the Black Water tank and Sewer Drain Hose.
4. When flushed, turn off the water and remove the Green Sewer Flush Hose from the Black Water flush connection.
5. Close the Black Water Flush Valve.
6. Pull open the Grey Water Flush Valve.
7. Allow the Gray Water to drain.
8. Turn on the water in a sink to flush the Gray Water tank and Sewer Drain hose.
9. Close the Gray Water Flush Valve.
10. Lift the Sewer Drain Hose close to the ROV and work the water down the line.
11. Remove the Sewer Drain Hose from the RV.
12. Use the Green Sewer Flush Hose to rinse the Sewer Drain Hose.
13. Lift the ROV end of the Sewer Drain Hose to completely drain it into the sewer.
14. Disconnect the Sewer Drain Hose from the sewer.
15. Use the green Sewer Flush Hose to rinse the Sewer Drain Hose connection.
16. Turn off the Green Sewer Flush Hose and remove it from the source.
17. Allow the Green Sewer Flush Hose to drain/dry as much as possible.
18. Store the Green Sewer Flush Hose.
19. Allow the Sewer Drain Hose to drain/dry as much as possible.
20. Replace the cap on the sewer drain line.
21. Store the Sewer Drain Hose.
22. Wash your hands and any place the got splashed by the sewer water.

If using Water:

• Set the water heater operating mode to Off.
• Turn off the water supply.
• Turn on the outdoor shower to relieve the pressure.
• Disconnect the hose from the RV.
• Disconnect the hose(s) from the source.
• Coil the hose(s) and store them.

If using external Electric.

1. Make sure the AC and any large electrical load is off.
2. Disconnect the cable from the source.
3. Coil and store the extension cord if used.
4. Coil and store the main cord.

Secure all interior items and latch cabinets.

Make sure all equipment is stored in the exterior cabinets and the cabinet doors are secured.

Make sure the slide is clear to retract on both the outside and inside.

Make sure the parking brake is engaged.

Start the engine.

Press the Slide In button until the slide is fully retracted.

Turn on the Leveling Jack system.

Press the All Retract button.  Wait for Operating light to go out.

Turn off the Leveling Jack system.

Make sure the jack legs are up.

Open the door and turn On the step retractor button.